Product#: 14097278

Starter Bolt 3/8"-16 X 4-11/16"

Replacement starter bolt for models that require a 3/8"-16 x 4-11/16" bolt.


Product#: 3733289

3/8"-16 X 3-5/8" Starter Mount Bolt

This replacement shouldered medium length bolt commonly used to secure starters with a cast iron staggered pattern nose to a big block engine. Two bolts required per vehicle.


Product#: 30203

Painless Remote Starter Solenoid Set

This set allows you to position the starter solenoid any place you need to in order to make maintenance easier, clean up an inner fender or just replace a factory starting circuit. Installation Instructions: Download Here Set...


Product#: SS304G

1955-93 Long Version Gold Series Starter Solenoid

The solenoids are manufactured with a high-temperature insulated wire for better heat resistance, a nickel-plated mounting bracket for better ground and an increased contact area on studs for higher electrical current...


Product#: 30201

Painless Hot Shot Plus Starter Solution; with Engine Bump Start Switch

The solution for vehicles with GM starters that are hard to start when hot, or vehicles with old or worn out electrical systems. Works by boosting available amperage to the starter solenoid. The Hot-Shot Plus model includes...


Product#: 30202

Painless Hot Shot Starter Solution; without Engine Bump Start Switch

The solution for vehicles with GM starters that are hard to start when hot, or vehicles with old or worn out electrical systems. Works by boosting available amperage to the starter solenoid. Installation Instructions:...


Product#: SS304

1958-81 Long Version Starter Solenoid

The starter motor solenoid commonly needs to be replaced due to heavy use and heat which is generated from the engine and exhaust manifolds.


Product#: RX6004

1955-81 GM; Starter Motor Brush Set

When rebuilding your original starter motor, it is usually necessary to replace the brushes. The brushes are the most commonly worn out part of the starter which can cause failure. These brushes are stamped 945 and contain a...


Product#: TT1002

Starter Heat Shield Set

In today's high-heat environment, starters take in a lot of damaging heat that destroys the windings of the starter and solenoid. To combat this problem, we offer a non-conductive strap-on heat shield with a highly-reflective...

Starter Heat Shield Set

MSRP $30.99 set
Classic $27.99 set

Product#: G5111

1966-81 Small Block 168 Tooth Starter Motor Brace

Over a period of years, the starter motor braces are usually lost or discarded when the starter is replaced. Without this brace, undue strain will occur to the starter motor body causing wear or damage. When this happens you...


Product#: TA4021

1964-81 GM; Starter Shim Set; 5 Pieces

5-piece starter shim set for Chevrolet and Pontiac models. Set includes (1) 1/16" shim, (2) 1/32" shims and (2) 1/64" shims. They are used to shim the starter to the engine block.


Product#: G0103

Starter Bolt; 3/8"-16 X 4.33"; For 4.3L 5.0L 5.7L, or 502 Engine

Genuine GM starter bolts for various models. For 4.3L 5.0L 5.7L, or 502 Engine. Replaces GM Numbers 12338064, 09000852, or 10465167. Works with GM Performance 9000852 or 12606096 high-torque mini starters, also works with...